There have been a number of 21-inch (53.3cm) torpedoes in service with the Royal Navy of the United Kingdom.
Torpedoes of 21-inch caliber were the largest torpedoes in common use in the RN. They were used by surface ships and submarines; aircraft used smaller 18-inch torpedoes.
The first British 21-inch torpedo came in two lengths, "Short" at 17 ft 10.5 in (5.45 m), and "Long" at 23 ft 1.25 in (7.04 m). The explosive charge was 200 lb (91 kg) of guncotton, increased later to 225 lb (102 kg). The torpedoes were first deployed in the field in 1912 and primarily used by the Beagle-class destroyers throughout most of their service during the First World War.[1]
Specifications:[2][3]
Mark I Short
Mark I Long
The Mark II, chiefly used by destroyers, entered service in 1914. Apart from some older British ships, it was used with the old US (destroyers-for-bases deal) Town-class destroyers provided to the UK during the early part of the Second World War. The running speed was reduced from 45 kn (83 km/h) (over 3,000 yards) for better reliability.
The Mark II*, an improved Mark II, was used by battleships and battlecruisers. A wet heater design, it could run for 4,500 yd (4,100 m) at 45 knots (83 km/h).
The Mark IV torpedo was the principal British torpedo of World War I. Designed 1912, initially available 1915, adopted for service 1916. Used by destroyers, torpedo boats, and other surface ships equipped with 21-inch torpedo tubes, such as the Royal Sovereign-class battleships. In the Second World War they were carried as auxiliary armament on submarines and various surface ships, including HMS Hood.
Specifications:[4][5]
Mark IV
Mark IV*
Mark IV Late[6]
The Mark V was used by the A and B-class destroyers and, with modification, by the Kent-class heavy cruisers.
The Mark VII was issued for use on the British heavy cruisers, i.e. cruisers with 8-inch guns. Designed in the mid-1920s the County-class cruisers were built at the same time in the post Washington Naval Treaty period.
The power came from the use of oxygen-enriched air, though torpedo stocks were converted to run on normal air at the start of the Second World War.
The Mark VIII was designed circa 1925 and was the first British burner cycle design torpedo. It was used from 1927 on all submarines, beginning with the later versions of the L class and the Odin class, as well as motor torpedo boats. The principal World War II version was the improved Mark VIII**, 3,732 being fired by September 1944 (56.4% of the total number). The torpedo was still in service with the Royal Navy in a training role until recently, and was used by the Royal Norwegian Navy (Coastal Artillery: Kaholmen torpedo battery at Oscarsborg Fortress) until 1993.[7]
Specifications:[8]
Mark VIII
Mark VIII**
The Mark VIII** was used in two particularly notable incidents:
The Mark IX was designed circa 1928 and first deployed in 1930. The design was considerably improved by 1939. The Mark IX was a larger and longer-range sibling to the Mark VIII, employing a very similar four-cylinder radial kerosene-air burner-cycle propulsion system. Used on the Leander-class cruiser and later cruisers, A- and B-class destroyers, and later destroyer classes. Also replaced the old Mark VII torpedo in some 8 in (200 mm) gun cruisers during the war. The principal version used during the Second World War was the Mark IX**, first issued to J- and K-class destroyers in 1939. In 1943 it was decided to further improve the Mark IX** by lengthening it 12 inches (30.5 cm), and the weapon mass limit to 4,000 lb (1,800 kg), up to the capacity of torpedo tubes and ships under construction.[10] Nitromethane-augmented propulsion was considered, but its implementation required too many alterations to be practical. The final version of what would have become Mark IX*** took up the extra space by enlarging the warhead to 930 lb (420 kg) of Torpex. None were in service by the end of the war in 1945, by which time the enlarged warhead became unnecessary. The Mark IX torpedo remained in service throughout the 1960s.[11]
Specifications:[12]
Mark IX
Mark IX*
Mark IX**
From 1939, used by submarines, motor torpedo boats and destroyers from other navies such as the Grom-class destroyers.[citation needed]
Electric battery-powered torpedo with a 710 lb (322 kg) TNT warhead. It entered service during the Second World War and was used by destroyers.
A design for a high-speed torpedo propelled by high-test peroxide (HTP), based on wartime research by Hellmuth Walter during the Second World War. At first codenamed "Ferry", then "Fancy", the Mark 12 never moved past the prototype stage. The design was conceived in 1945, after the end of the war in Europe, with the arrival of technical documentation from Germany. For economical reasons, the Mark VIII torpedo body was used, in an effort to adapt it to HTP propulsion.[13] The "Ferry" was supposed to be a surface-running torpedo with a gyroscopically-guided search pattern. Prototypes of the weapon were ready in 1953, except for the pattern-running feature, which was then omitted and the weapon was redesignated as "Fancy". In 1954, several prototypes were issued to HMS Maidstone and over 200 test runs were carried out until a catastrophic accident. On 16 June 1955, HMS Sidon was alongside HMS Maidstone in Portland Harbor, preparing to make way to Stage II trials of the "Fancy". Crewmen on the submarine were in the process of loading one of the prototype torpedoes into a launch tube, when the stop valve on the weapon was accidentally opened, triggering the release of reactant in its propulsion unit. The weapon exploded inside the launch tube, simultaneously blowing out the bow caps as well as the rear hatch of the launch tube. A blast of debris and dense carbon dioxide were propelled into the submarine. Two officers and ten seamen were killed instantly, six from the initial blast and six more by asphyxiation from the ejected gases. One more victim, a doctor from the Maidstone, subsequently perished in an effort to rescue the crew from the submarine. The submarine sank in shallow water due to flooding from the blown-open launch tube. Ultimately the accident caused enough damage to have the submarine taken permanently out of service.[14] Following this accident, a second Mark 12 Fancy exploded at the Arrochar torpedo range in Loch Long, Scotland. As a consequence of these accidents, and the perceived hazardous nature of HTP propulsion, the program was cancelled in 1959.
Specifications:[15]
Mark 12
The Mark 20 was a passive-seeker battery-powered torpedo which was initially conceived in 1945, as a 21-inch development of the 18-inch "Dealer" project for a parachute-dropped ASW weapon, conceived in 1943.[16] At the end of the Second World War the "Dealer" project was renamed "Dealer A" and became further branched out into the 21-inch "Bidder" and 18-inch "Dealer B" projects.[17] Thus, the Mark 20 was developed alongside the 18-inch Mark 30 Dealer B and shared elements of its design.[18] The development program was elevated in scope and priority after the cancellation of the Mark 21 Pentane. Two variants were developed: the Mark 20S ("Submarine") for use by submarines, and a larger Mark 20E ("Escort") for use by surface ships. The S variant had a single speed of 20 knots, and the E variant had a dual-speed mode of 15 knots and 24 knots, for target search and subsequent autonomously-switched attack run.[19] In the E configuration, the torpedo was designed to have a total endurance of 20,000 yd (18,000 m) at the 15 knot speed, and 6,000 yd (5,500 m) upon switching to the 24 knot speed.[20] A total of 75 units of the Mark 20E were produced, with trial samples being distributed to the Type 12, Type 14, and Type 15 classes of frigates. As of 1958, the E variant was still not ready for service due to problems with its programming, and the prospect of a medium-range ASW torpedo being carried by the upcoming Westland Wasp helicopter was deemed more desirable. The deficient speed of the Mark 20 was also a motivating factor. As a result, the E variant project was eliminated, leaving only the S variant. This led to several of the frigates that were intended to have used them (Rothesay and Whitby classes) never being fitted with torpedo tubes or having them removed. As of 1959, the only destroyer class projected to carry the Mark 20 was the Leander,[21] but as of 1963, this design consideration would also be eliminated.[22] The final version of the Mark 20 Bidder was referred to as the Mark 20 Improved.[23] The Mark 20 Improved entered service in 1971, originally developed by Vickers Shipbuilding and Engineering as an export version. It featured weight reductions to its synchromechanisms and the contra-rotating propeller gearing, and the earlier mechanical course and depth setting devices were replaced by electronic ones, receiving data from the launch console via an umbilical link. These improvements, together with new batteries common to the Mark 23, slightly increased torpedo endurance.[24]
In 1965, Captain John Moore of the Royal Navy developed a variant of the Mark 20 which he dubbed "Archimedes". This was an underwater, submarine-launched, equipment delivery vehicle designed to support clandestine operations, particularly those of the frogmen of the Special Boat Service.[25] The warhead was removed and replaced with a sealed cargo capsule. Like other such vehicles of the type, the "Archimedes" could beach itself in a controlled manner, allowing frogmen or other clandestine agents to open the capsule and retrieve its contents. The vehicle could also be directly piloted by a frogman, with variable speeds, functioning as an underwater tug and diver propulsion vehicle. The prototype of the "Archimedes" was a larger Mark 23 torpedo, but the series-production version utilized a Mark 20 body.[26] Captain John Moore was quoted as referring to the Mark 20 as "a useless device for its original task".[27]
The Mark 20 was the only torpedo in service which could fit the short stern launch tubes of the Oberon and Porpoise-class submarines. It remained in the submarine service until 1988, which is when the Porpoise class were retired.[28] Following experience in the 1982 Falklands War, when an armed Mark 20 became stuck inside its tube and HMS Onyx was forced to return to Portsmouth to have it removed, the Oberon class would relegate the stern launch tubes for storing beer, retiring the Mark 20 sooner.[29]
A project for an autonomous active sonar ASW torpedo to be carried by the Avro Lancaster, Avro Shackleton, Short Sturgeon and Fairey Gannet aircraft in an anti-submarine role, originally conceived in 1947.[30][31] Development commenced in 1949, and a final design was selected in 1954, delivering functional prototypes with a speed of 30 knots. By this time several of the aircraft capable of carrying a 21-inch torpedo were in the process of being withdrawn from service. Following the 1957 Defence White Paper, which de-emphasized the role of aircraft carriers, the RAF Coastal Command was left as the sole operator and the project was cancelled in 1958 due to cost considerations and an assessment that the weapon lacked the speed to counter upcoming nuclear submarine designs. The seeker head development was transferred to Project Ongar, which would later become the Mark 24 Tigerfish.[32]
A wire-guided version of the Mark 20 separately developed by Vickers Shipbuilding and Engineering (VSEL) as a private venture. The project was cancelled in 1956, but the wire guidance technology was transferred to the Mark 20 Bidder, contributing to the development of the Mark 23 Grog.[33]
A wire-guided version of the Mark 20 with a dual-speed mode, for target approach and attack run.[34][35] Wire guidance had been worked on for the "Bidder" project from its inception, and the earliest prototypes of the "Grog" were available for testing in 1955. After the "Mackle" project was cancelled in 1956, the complex wire guidance system was transferred to the "Grog" program. This would be simplified, improved, and the first production units of the Mark 23 Grog were delivered in 1959.[36] The Mark 23 was fitted with a 10,000 m (11,000 yd) outboard dispenser that contained a control wire to guide the weapon. Wire guidance was optional, with the control wire spool being a separate module which remained inside the launch tube. An operator onboard the submarine would listen to the torpedo's hydrophones, guiding the weapon past decoys and countermeasures.[37] Entered service in 1966 although already obsolescent,[38] considering the common speeds of nuclear-propelled submarines of the era. According to one report, the weapon did not become fully operational until 1971,[39] and served until 1987, which is when all stocks of the Mark 24 Tigerfish were converted to Mod 2.
During the trials phase of the Mark 23, in 1965, Captain John Moore of the Royal Navy experimented with a sample of the torpedo body. Royal Navy engineers aboard the submarine depot ship HMS Medway (former HMS LCT 1109) modified the torpedo body to his specifications, into a human torpedo prototype, with the primary function of an underwater tug. Supplementary batteries were added, increasing the vehicle's range. Ultimately the Mark 20 torpedo body would be selected for a similar vehicle, which went into series production.[40]
During 1973, all of the RN torpedoes had to be taken out of service as the control system was failing at extreme range.[citation needed]
After months of investigation, it was discovered that the fault lay in the Guidance Unit made by GEC. A germanium diode in the automatic gain control (AGC) circuit had been replaced by a silicon diode, following an instruction by RN stores that all germanium diodes had to be replaced by more modern silicon diodes. The silicon diode's different characteristics caused the AGC circuit to fail. Once the mistake was found, replacing the diode with the original type cured the problem.
The Mark 24 Tigerfish was a high-speed, long-range, wire-guided torpedo originally developed under Project Ongar. The staff requirement for this weapon was written in 1959[41] and the weapon was expected to enter service in the mid-1960s, with an in-service target date of 1969.[42] Initial production rounds were delivered in 1974, and a production order was made in 1977. Affected by the budgetary constraints of the 1966 Defence White Paper, the first Tigerfish (Mod 0) entered deployment in 1983. All variants of the Tigerfish were removed from service in 2004.
The Mark 24 Tigerfish had a protracted development program, beginning with the initial two models, then studies to tackle its deficiencies, and finally a Marconi Consolidation Program (nicknamed "Get Well") undertaken in the late 1980s to convert existing units to the Mod 2 standard.
Much more capable than Tigerfish. Deployed from 1992, and replacing all Tigerfish by 2004.